Feed Customization
Express feed value in μm instead of mm
To change the Sync Feed ( mm/rev | inch/rev ) set [Feed Sync Multiplier] to 1000 .
To change the Async Feed ( mm/min | inch/min ) set [Feed Async Multiplier] to 1000 .
The default value will be multiplicated per 1000.
Drilling Feed Mode
To select between the sync or async feed used in drilling operation ( drilling, boring, tapping, ecc.. ) change the [Drilling Feed Mode]
Milling Feed Mode
To select between the sync or async feed used in milling operation ( pocketing, face milling, contouring ,ecc.. ) change the [Milling Feed Mode]
Lathe Feed Mode
For Lathe machines
By default in lathe machine is selected the synchronous feed mode ( mm / rev ).
If your machine need the feed expressed in asynchronous mode ( mm/min ) , you need to set the property [Lathe Feed Mode] in PREFERENCE dialog.
Probably you need to increment the decimal count for ASYNC feed , see section below codes.
Decimal Count Customization
From Post Processor dialog, is possible to customize the decimal count number for following codes :
- Coordinate codes
- Feed Sync and Async codes
- Speed Codes
